- MAC ADDRESS FOR CISCO SMALL BUSINESS ROUTER HOW TO
- MAC ADDRESS FOR CISCO SMALL BUSINESS ROUTER PASSWORD
You will also notice there is no IP, Default Gateway, or DNS server listed on the WAN interface.Ĭonfiguring MAC Address Clone on an RV160 or RV260 Router Most likely, you will see the WAN interface status is showing connected. Navigate to Status and Statistics > System Summary. Note: In this example, a D-Link router is selected. Note the MAC address details of the WAN interface for the known working third-party router. Make sure the Connection Type on the WAN interface is configured as DHCP.
MAC ADDRESS FOR CISCO SMALL BUSINESS ROUTER PASSWORD
Otherwise use your pre-configured username and password to log in to the router. Note: Enter the username and password as cisco if the router is in default configuration.
MAC ADDRESS FOR CISCO SMALL BUSINESS ROUTER HOW TO
For information on how to access the GUI of Cisco VPN router, click here. Log into the router to access the Graphical User Interface (GUI). Then the RV160 or RV260, showing the cloned MAC address on its WAN interface, will be able to get a DHCP IP address and resume the connection. In this example, the MAC address of the WAN interface of the D-Link will be cloned. If it can, the RV160 or RV260 can clone the MAC address of that third-party router.
Can that router get a DHCP IP on the WAN interface using the same ISP link? If rebooting the router doesn’t work, and your network contains a separate, pre-configured third-party router, such as D-Link, check that router out. Due to that, the ISP will not assign any DHCP IP to the unknown devices. Most likely, the ISP has configured MAC address binding on their side for the known devices. However, for some reason, the WAN interface is unable to get an IP from their Internet Service Provider (ISP). DHCP is also used to configure the correct subnet mask, default gateway, and Domain Name System (DNS) information on the device.Īt some point, you may observe that the WAN interface of an RV160 or RV260 router is configured to DHCP. It is a simple way to maintain a network, as it is all done automatically, without intervention from an administrator. DHCP manages a pool of available IP addresses, assigning them to hosts as they join the network. When a network device is configured, it is common to utilize Dynamic Host Configuration Protocol (DHCP) for both Local Area Network (LAN) and Wide Area Network (WAN) IP addresses. It is physically located on the device and contains 12 hexadecimal numbers. It is good to know your MAC address when setting up a network and troubleshooting. Each MAC address is unique to every device. IntroductionĮvery device has its own Media Access Control (MAC) address. This article explains how to configure MAC Address Clone using an RV160 or RV260 router.
0 kommentar(er)
